King Comfort Air
✓ Licensed 24/7
Home › Cost Guides › HVAC Technician Cost › Carrollton, TX
❄️ Cost Guide · Carrollton, TXA hvac technician in Carrollton charges $67/hour for a standard service call — that's 8% below the US median of $73/hour. The differential reflects the TX cost-of-living composite of 92.7 (US average = 100) applied to BLS OEWS national mean wage data for SOC 49-9021.
| Project | Time | Typical cost | Range |
|---|---|---|---|
| Diagnostic service call (no parts) | 45–90 min | $67 | $55 – $81 |
| Annual AC or furnace tune-up | 60–90 min | $124 | $102 – $149 |
| AC repair (capacitor / contactor / minor part) | 1–3 hours | $302 | $247 – $362 |
| Refrigerant recharge (R-410A, residential) | 1–2 hours | $361 | $296 – $433 |
| Smart thermostat install | 1 hour | $268 | $220 – $322 |
| Gas furnace replacement (80% AFUE, 80k BTU) | 1 day | $2,764 | $2,267 – $3,317 |
| Heat pump replacement (3-ton, 16 SEER) | 1–2 days | $6,320 | $5,183 – $7,584 |
| Mini-split install (single zone, 12k BTU) | 1 day | $2,301 | $1,886 – $2,761 |
| Whole-home duct cleaning | 3–5 hours | $325 | $267 – $390 |
Sources: BLS OEWS May 2024 (SOC 49-9021), MERIC State Cost of Living Index 92.7 for TX, NAHB Construction Cost Survey 2024.
At an effective contractor rate of $67/hour, Carrollton sits right around the national median for hvac technician work. Homeowners here will see lower-than-average prices on labor-intensive jobs (re-pipes, panel upgrades, full system replacements) where labor is the bulk of the cost. Materials-heavy jobs (water-heater swaps, furnace replacements, large appliance installs) will track somewhat below the national figure because regional materials inflation in TX runs about 7% below the US benchmark.
A residential HVAC technician services, repairs, and installs forced-air furnaces, central AC, heat pumps, mini-splits, and ductwork. A diagnostic visit typically includes static-pressure measurement, refrigerant pressure (for cooling systems), temperature differential between supply and return, electrical-component testing (capacitor microfarad, contactor pull-in, transformer voltage), and ignition or burner inspection on heating equipment. Installations require Manual J / Manual D / Manual S calculations to size the equipment correctly — beware any installer who skips these and recommends "the same size you have now."
"Same-size replacement" without a load calc, refrigerant-only quotes that don't address the leak, and any installer who pushes the largest unit without explaining why.
See all HVAC Technicians in Carrollton →