Schultz Comfort Air
✓ Licensed 24/7
Home › Cost Guides › HVAC Technician Cost › Savannah, GA
❄️ Cost Guide · Savannah, GAA hvac technician in Savannah charges $66/hour for a standard service call — that's 10% below the US median of $73/hour. The differential reflects the GA cost-of-living composite of 90.8 (US average = 100) applied to BLS OEWS national mean wage data for SOC 49-9021.
| Project | Time | Typical cost | Range |
|---|---|---|---|
| Diagnostic service call (no parts) | 45–90 min | $66 | $54 – $79 |
| Annual AC or furnace tune-up | 60–90 min | $122 | $100 – $146 |
| AC repair (capacitor / contactor / minor part) | 1–3 hours | $295 | $242 – $355 |
| Refrigerant recharge (R-410A, residential) | 1–2 hours | $353 | $290 – $424 |
| Smart thermostat install | 1 hour | $262 | $215 – $315 |
| Gas furnace replacement (80% AFUE, 80k BTU) | 1 day | $2,707 | $2,220 – $3,249 |
| Heat pump replacement (3-ton, 16 SEER) | 1–2 days | $6,191 | $5,076 – $7,429 |
| Mini-split install (single zone, 12k BTU) | 1 day | $2,253 | $1,848 – $2,704 |
| Whole-home duct cleaning | 3–5 hours | $319 | $261 – $382 |
Sources: BLS OEWS May 2024 (SOC 49-9021), MERIC State Cost of Living Index 90.8 for GA, NAHB Construction Cost Survey 2024.
At an effective contractor rate of $66/hour, Savannah sits meaningfully below the national median for hvac technician work. Homeowners here will see lower-than-average prices on labor-intensive jobs (re-pipes, panel upgrades, full system replacements) where labor is the bulk of the cost. Materials-heavy jobs (water-heater swaps, furnace replacements, large appliance installs) will track somewhat below the national figure because regional materials inflation in GA runs about 9% below the US benchmark.
A residential HVAC technician services, repairs, and installs forced-air furnaces, central AC, heat pumps, mini-splits, and ductwork. A diagnostic visit typically includes static-pressure measurement, refrigerant pressure (for cooling systems), temperature differential between supply and return, electrical-component testing (capacitor microfarad, contactor pull-in, transformer voltage), and ignition or burner inspection on heating equipment. Installations require Manual J / Manual D / Manual S calculations to size the equipment correctly — beware any installer who skips these and recommends "the same size you have now."
"Same-size replacement" without a load calc, refrigerant-only quotes that don't address the leak, and any installer who pushes the largest unit without explaining why.
See all HVAC Technicians in Savannah →